• For Types 1 & 2
• For Type 3
• For Types 10A & 10B

End Configurations for Types 1 & 2 Seals

In the ends of Type 1 and Type 2 seals there is a solid non-expanding portion at the extreme end followed by a transition area where the expansion gradually increases until it reaches the full sealing position, as shown in the illustration below.

 

l
Standard Boot End Dimensions
Seal A 1* B 1* C D E

PRS573
PRS537
PRS535
PRS548
PRS717
PRS580
PRS582
PRS583
PRS705
PRS729
PRS590
PRS584

 7/8
1 1/8
1 3/16
1 11/16
7/8
1 1/8
1 1/2
2 1/4
2 3/8
3 1/2
5 1/2
2 3/8		 2 3/8
1 7/8
2 1/4
3 1/4
2 3/8
3 1/8
3 1/2
4 1/8
4 1/8
5
9 1/2
4		 7/16
3/4
11/16
1 3/16
1/2
5/8
1
1 3/4
1 7/8
3
4 3/4
1 7/8		 7/16
5/8
7/8
11/4
1/2
5/8
7/8
1 ¼
1 5/8
1 5/8
2 1/16
1		 11/16
1
1 5/8
1/4
13/16
1
1 5/8
2 1/2
3 3/8
3 1/4
4 1/16
3
 
  1. *"A" Denotes - standard end, "B" Denotes - extended end.
  2. Dimensions on "A", "B" & "C" are approximate to within 3/32.
  3. "D" dimension equals deflated height of seal."E" dimension equals maximum inflation height.

Strip seals should be securely clamped as illustrated below. For clamp dimensions, consult Pawling.

Fig 1. Fig 2. Fig 3. Fig 4.

 

 

 

Home | Site Map

©2006 Pawling Corporation, Engineered Products Division
 157 Charles Colman Blvd. Pawling, NY 12564-1193 USA

(845) 855-1000 | (800) 431-0101 | Fax: (845) 855-1139 USA
West Coast: (949) 475-9842 | Fax: (949) 475-9859

epdinfo@pawling.com

Site Development & Design: Greener Pastures Design & Illustration