 |
|
|||||
|
|
|
|||||
|
Recommended Retainer Groove: Types 2, 4, 10A & 10B
 |
RW = seal profile width (w dimension) with its plus tolerance RH = seal profile height (H dimension) with its plus tolerance Surface finish of bottom of machined groove should be 63 microinch or better with finish lay parallel to seal. |
For circular, radial expansion inward/outward configurations, especially smaller diameters, seals are sized so that their tension or compression forces are generally sufficient to hold them in place. If used in other configurations, adhesives are generally required.
©2006Pawling Corporation, Engineered Products Division
157 Charles Colman Blvd. Pawling, NY 12564-1193 USA
(845) 855-1000 | (800) 431-0101 | Fax: (845) 855-1139 USA
West Coast: (949) 475-9842 | Fax: (949) 475-9859
epdinfo@pawling.com
Site Development & Design: Greener Pastures Design & Illustration
